Instruments - Rudder Angle , Boat Outfitting

Sort By:  
37982XL.jpg
Raritan - Raritan MK2 Rudder Angle Indicator (37982)
MK2 Rudder Angle Indicator

Rudder angle indictators are economical steering aids and rudder position monitors.

Features:
  • Useful aid for docking or close maneuvering
  • Constant monitoring of rudder angle position from 0 to 45 degrees
  • Ready for installation with all necessary components needed - meter, calibration box and sending unit
  • MK2 model
  • 2" Round
  • Sprayproof (IP64)
  • Backlit
$553.49
38855XL.jpg
Raritan - Raritan MK5 Rudder Angle Indicator (38855)
MK5 Rudder Angle Indicator

Rudder angle indicators are economical steering aids and rudder position monitors.

Features:
  • Ready for installation with all necessary components needed - meter, calibration box and sending unit
  • Constant monitoring of rudder angle position from 0°-45°
  • Great aid for docking or close maneuvering
  • Each unit is assembled by hand, individually tested and backed by Raritan's 1-year Limited Warranty and legendacry technical support team
  • Repeater units are available for multiple station readouts
  • Rudder Indicator with 4-1/2" flush mount panaoramic meter
$569.61
48520XL.jpg
ComNav Marine - ComNav Analog Rudder Angle Indicator Meter (48520)
Analog Rudder Angle Indicator Meter

The analog rudder angle indicator is a backlit 76mm (3in) gauge displaying the actual position of a vessels rudder. All ComNav Autopilots come with built in electronics to drive at least three meters without additional interfacing.

Features:
  • Flush mount
  • Water resistant front face
  • Supply voltage for lighting 10-40VDC
Out of Stock
$343.83
48521XL.jpg
ComNav Marine - ComNav Stand Alone Rudder Angle Indicator System (48521)
Stand Alone Rudder Angle Indicator System

Complete single station RAI system typically used on vessels that do not have a ComNav autopilot or, in cases where a separate RAI system is required (such as Hydraulic Full Follow-up steering systems). The Stand Alone System consists of three components:
  • ComNav Rudder Follower w/50' cable and linkage kit
  • RAI Distribution Box w/special circuitry
  • ComNav 3" Rudder Angle Indicator
Out of Stock
$1,143.07
49738XL.jpg
ComNav Marine - ComNav RAI Watertight Case f/Analog Rudder Angle Indicator (49738)
Rudder Angle Indicator Watertight Case

The Rudder Angle Indicator Watertight Case is a good alternative for outdoor applications where flush mounting the RAI may not be possible. In these cases or, when the back of the RAI may be exposed to moisture, we recommend the watertight case. The kit comes complete with case, O-ring seals, screws and two watertight cable glands.
Out of Stock
$125.81
61919XL.jpg
Simrad - Simrad RI35 Mk2 Rudder Angle Indicator (61919)
RI35 Mk2 Rudder Angle Indicator

The RI35 Mk2 is manufactured in non-corrosive aluminum with a non-reflective black finish. It is designed to operate from frequency or current signals generated by a Simrad autopiloy feedback unit. It will also accept a NMEA 0183 rudder angle (RSA) signal. The indicator is made in standard modular size (132 x 108mm) to match the Simrad AP35 autopilot. A separate PCB is mounted inside the instrument to convert the input signals and drive indicator.

The instrument gives a continuous reading of the rudder position up to 45° on either side of the midship's position. With no signal input the pointer moves out of scale to port. A front key panel is used for illumination and setup adjustments. The splash proof construction allows panel, bulkhead or bracket mounting in exposed locations, such as bridge wings as well as wheel house and engine room.
Out of Stock
$944.75
Per Page      1 - 6 of 6
  • 1